ANTENTOP- 01- 2008, # 010

Fixture for Fast Assembling of VHF- Antennas

You can see that antenna parts are reliable fastened to the boom, it is possible to move these ones along the boom as well as fast to remove the parts apart the boom.

Oh, yes, I forget, you need a traveler that should fit to the boom. I did such traveler from a plexiglass in 10- millimeters (near ½-inch) thick. Design of the traveler is clear shown at the pictures. The traveler should sit at the boom evenly not crookedly. Off course, is it possible to use for design of traveler any suitable staff (instead plexiglass). Local craft shop for sure gives you lots ideas.

73! UA9UKO

Antennas after hail. Picture by LZ2ZK

http://www.antentop.org/

Page 50