antentopSince2 July

** PLEASE DESCRIBE THIS IMAGE **
** PLEASE DESCRIBE THIS IMAGE **
** PLEASE DESCRIBE THIS IMAGE **

 

 

 

 

 

Antentop is FREE e-magazine devoted to Antennas and Amateur Radio an

Special page devoted to

Vertical ZL- Beam Antenna for 430- MHz

Custom Search

 

ANTENTOP- 02- 2010, # 014

Vertical ZL- Beam Antenna for 430- MHz

 

Figure 2 J- Antenna

 

Stub provides two antiphased RF voltages at its ends. Dipoles at the ZL- beam fed by antiphased RF voltages. So, it is possible to connect vertical dipoles to the ends of the stub. Phase shift between dipoles should be got by shortening left one and lengthening right one.

To obtain space between the dipoles lambda/8 it needs just bend each dipole. Figure 3 shows the ready Vertical ZL- Beam Antenna for 430- MHz. Antenna. Antenna was made from one length of a copper wire in diameter 1.7- mm (14- AWG).

 

Figure 3 Vertical ZL- Beam Antenna for 430- MHz

A Diagram of Directivity

B Feeding Points

C Dimensions of the Antenna

My practical measurement showed that the antenna had one sided lobe (Figure 3, A) and 4- dB gain over a usual half-wave dipole.

 

References

1.

http://www.eham.net/ehamforum/smf/index.php?topic=13700.0

2. www.hamuniverse.com/gi6jpozl-special.pdf

3.

http://www.dxzone.com/catalog/Antennas/J-Pole/

4. http://en.wikipedia.org/wiki/J-pole_antenna

 

www.antentop.org

Page- 69

 

68 69

 

 

 


 

 

Just for Fun:

Map IP Address
Powered byIP2Location.com

Thanks for your time!

Last Updated:

January 19, 2020 22:00

** PLEASE DESCRIBE THIS IMAGE **

** PLEASE DESCRIBE THIS IMAGE **

2003entop